Connecting Power
The battery on the vehicle serves as the power source for the Shadow Tracker™
units however, if a unit is left on for an extended period in which the vehicle is not
running the unit may drain the vehicle battery to the point that the vehicle cannot
be started.
™
The adapter should be connected to the vehicles power source.
Carefully, connect the receiver adapter to the back of the Shadow Tracker unit
paying special attention not to bend any of the connector prongs.
Refer to: Wiring Instructions of this manual for further explanation.
3
CONNECTING THE UNIT
Mounting and Placement
Mounting devices used and the specific placement location of the Shadow
Tracker Premier in the vehicle is left to the discretion of the end-user.
It is important, when considering the placement location for a unit, to
bear in mind that it is that the transmit antenna (located inside the
Shadow Tracker Premier) be kept at least 23 cm away from any nearby
persons in order to satisfy FCC RF exposure requirements
Note:
required
™
™
To Next Page
Loading...
