CUTTING HEIGHT ADJUSTMENT:
Turn the handle to raise or lower as necessary.
READ AND UNDERSTAND THE ENGINE OPERATORS
MANUAL BEFORE USE
Observe all safety precautions; keep hands and feet away from rotor and other moving
parts. Keep spectators at a safe distance.
1. Make sure there is a gap between the blades and the ground / crop
2. Select an area clear of loose debris that could be picked up.
3. Set the engine choke, and suitable idling speed with the throttle.
4. Place one foot on top of the deck body to give a firm and balanced position. Pull the starter
cord firmly, allowing the cord to return to return to the housing slowly (one or two strong pulls
should start the engine).
5. After a few seconds warming up at idling speed, move the throttle to the factory pre-set
working position to give a normal/working engine R.P.M of 3600 max.
ELECTRIC START
Push button electric start engine options can be supplied if required. Simply hitch up the mower,
connect the electrical supply plug to the ATV socket and turn the ignition key to start the mover.
Observing all the precautions mentioned above in ‘Starting the mower’.
REMOTE THROTTLE CONTROL
When a remote throttle control option is fitted, normally to the rear carrier frame of an ATV or other
suitable site on the towing vehicle, it gives the operator the facility of controlling the mower engine
NOTE: If the throttle is altered to increase the engine R.P.M beyond the recommended level, the
guarantee may become invalid. In addition to this, cutting efficiency will be reduced, fuel consumption will
increase and excessive vibration could be caused, resulting in a potential danger to personnel and damage to
components.
To Next Page
Loading...
