Need help?Do you have a question about the ATV MOW and is the answer not in the manual?
Perform pre-operation checks including securing fittings, removing packaging, and verifying oil and fuel levels.
Adjust the drawbar height to ensure the cutting deck is level for optimal cutting efficiency.
Utilize the screw jack to raise or lower the cutting deck to achieve the desired cutting height.
Read manual, observe safety. Set choke/throttle. Use foot for balance, pull cord firmly. Warm up and set RPM.
Adjust forward speed according to cutting conditions to prevent engine strain and drive belt damage.
Allow engine to cool at half speed for 4 minutes. Check hot parts, align drawbar, and clear debris.
Raise deck to highest position. Stop engine and blades, then remove debris before moving.
Prevents ground damage from uneven terrain and allows kerb-side cutting. Adjustable for cutting height.
Consult the engine manufacturer's manual for specific servicing and maintenance procedures.
Remove crop residue from deck and engine to prevent overheating and fire hazards. Disconnect spark plug.
Inspect mower for loose, missing, or damaged components. Repair or replace all identified faults.
Regularly check tyre inflation pressures and ensure they do not exceed recommended limits.
Rotate rotor shaft by hand, checking for roughness and play. Inspect bearings if abnormalities are found.
Lift wheel, check alignment and play. Inspect bearings if any looseness is detected.
Examine coupling for wear or damage. Check bushes for wear and replace if necessary.
Verify fastener tightness, guard and chain integrity. Ensure all safety decals are present and legible.
Replace damaged hammers promptly to maintain balance. Check opposite hammers for wear and replace as needed.
Perform pre-operation checks including securing fittings, removing packaging, and verifying oil and fuel levels.
Adjust the drawbar height to ensure the cutting deck is level for optimal cutting efficiency.
Utilize the screw jack to raise or lower the cutting deck to achieve the desired cutting height.
Read manual, observe safety. Set choke/throttle. Use foot for balance, pull cord firmly. Warm up and set RPM.
Adjust forward speed according to cutting conditions to prevent engine strain and drive belt damage.
Allow engine to cool at half speed for 4 minutes. Check hot parts, align drawbar, and clear debris.
Raise deck to highest position. Stop engine and blades, then remove debris before moving.
Prevents ground damage from uneven terrain and allows kerb-side cutting. Adjustable for cutting height.
Consult the engine manufacturer's manual for specific servicing and maintenance procedures.
Remove crop residue from deck and engine to prevent overheating and fire hazards. Disconnect spark plug.
Inspect mower for loose, missing, or damaged components. Repair or replace all identified faults.
Regularly check tyre inflation pressures and ensure they do not exceed recommended limits.
Rotate rotor shaft by hand, checking for roughness and play. Inspect bearings if abnormalities are found.
Lift wheel, check alignment and play. Inspect bearings if any looseness is detected.
Examine coupling for wear or damage. Check bushes for wear and replace if necessary.
Verify fastener tightness, guard and chain integrity. Ensure all safety decals are present and legible.
Replace damaged hammers promptly to maintain balance. Check opposite hammers for wear and replace as needed.
General| Brand | ATV |
|---|---|
| Model | MOW |
| Category | Lawn Mower |
| Language | English |
To Next Page
