6.3 VISUAL CHECK
Make a visual check around the mower, check for missing / loose parts or damaged / worn
components. All-faults must be either repaired or replaced.
6.4 TYRE PRESSURES
6.5 ROTOR BEARING INSPECTION
Rotate rotor shaft by hand and feel for any roughness in the bearings. Also try to pull the shaft from
side to side to see if any movement is found. If symptoms persist strip down the rotor-housing unit
and inspect bearings.
6.6 WHEEL BEARING INSPECTION
Jack one side of the mower body up, so the wheel is just off the ground. Rotate the wheel by hand,
and check the wheel alignment. To check the bearing, try to move the wheel from left to right and feel
for any play in the bearings (A), ensure the wheel-locating bolt is tight before you start and follow any
jacking procedures. If any play is found remove the wheel and inspect bearings. Replace any faulty
bearings.
6.7 OIL 50mm COUPLING/BUSH WEAR
Check coupling for signs of damage or wear, swivel the coupling 36. degrees and check that the
bushes are not too worn. Replace any worn or damaged parts.
6.8 GENERAL INSPECTION
Check the mower to ensure all fasteners are tight and all safety guards / chains are intact and fitted
securely. Check all safety-warning decals, Replace any defective guards or damaged decals.
To Next Page
Loading...