The drawbar attachment height of the towing vehicle can vary. To accommodate adjustment, a screw
link is located beneath the drawbar. This should be lengthened or shortened so that the cutting deck
is horizontal to level ground. (This ensures a better cutting efficiency)
TO ADJUST
1. Unlock the locking nut (A)
2. Lengthen the link to lower the front of the deck or shorten to raise the deck.
3. Once the deck is level, re-tighten locking nut (A).
A
QUICK OFFSET DRAWBAR Unlock the nut and screw slide the drawbar to the desired position
and release the screw into the securing hole then lock the nut, as shown.
Hole Settings
The main cutting height adjustment is achieved by using the screw jack, to raise or lower the cutting
deck as necessary.
To Next Page
Loading...
