Aube Technologies TH146-P-2H1C User Manual (English)

To Next Page

TH146-P-2H1C 400-280-014-A 5/23/07 1/11

TH146-P-2H1C

Installation Guide

Programmable 2H1C Controller

The TH146-P-2H1C programmable controller can be used with any

of the following heating/cooling systems:

 Heat pump - 1H1C, 2H1C

 HVAC - 1H, 1C, 1H1C

The following devices can be connected to the controller:

 air recirculation fan

 humidifier

 dual-register meter (dual energy)

 remote control device (for the unoccupied mode)

• CT280-2H1C control module

• TH146-P console with two wall anchors and mounting screws

• AC144-03 outdoor temperature sensor (3 m or 10 ft) with mount-

ing clip (see section 2.6)

• RC845 relay (see section 2.4)

• AC146-410 plenum temperature sensor (see section 2.7)

• CT241 telephone controller (see section 2.9)

• AC130-12 wall plate

Configure the control module according to your type of heating/cool-

ing system using DIP switches on the back of the module.

Install the control module near the heating/cooling system, away

from any heat source.

Install the console in a central location. Avoid locations with air

drafts (e.g., top of staircase or air outlet) or stagnant air (behind a

door). Do not install the console on a wall hiding air ducts nor

expose it to direct sunlight.

NOTE: If this controller replaces an old thermostat, any two of the

wires that were connected to the thermostat can be used to connect

the user console to the control module. The maximum wiring length

is 30 m (100 ft).

CT280-2H1C Control Module

TH146-P User Console

AC144-03 Outdoor

Temperature Sensor

Removable

Connector *

Removable

Connector *

* To remove a connector from the control module, pry with a screwdriver.

1. Introduction

1.1

Applications

1.2

Supplied Parts

1.3

Accessories

2. Installation

2.1

Control Module (CT280-2H1C)

2.2

User Console (TH146-P)

400-280-014-A (TH146-P-2H1C) ENG.fm Page 1 Wednesday, May 23, 2007 4:12 PM

Other manuals for Aube Technologies TH146-P-2H1C

Specification1 page

Need help?

Do you have a question about the Aube Technologies TH146-P-2H1C and is the answer not in the manual?

Aube Technologies TH146-P-2H1C Specifications

General

Type	Programmable Thermostat
Power Supply	24 VAC
Display	LCD
Programmability	7-day programmable
Backlight	Yes
Application	Residential and commercial
Battery	No battery required
Temperature Range	40°F to 85°F (5°C to 30°C)
Compatibility	Compatible with heating and cooling systems