- 22 -
Fig. 27. Bend the wire for easier to insert.
5) Install a cable tie as strain relief.
Place a cable tie at 1.3 to 2 inch away from the back of the controller. Cut off the tail of
the tie. This tie will function as strain relief to preventing the wire from being pulled off
the terminal.
Fig 28. Install a cable tie as strain relief.
6) Install the controller to the box. Screw the front panel on first. Make sure the controller
top and box top (the smooth surface) matches. Then, gently pull the cable out from the
back panel of the box until it is stopped by the strain relief. Screw on the back panel.
Make sure the rubber grommet is on the left upper corner (viewing from back). Fig 29.
To Next Page
Loading...
