Auber Instruments WS Series - Recalling and Managing Recipes; Recipe Saving Selection; Initiating Recipe Recall

20
Use “+” or “-” key to select the name of recipe to which you want to store the program. If
you press “+” (or “-” key) repeatedly, you will see “End”, “b1”, “b2”, “C1”, “C2”, “F1”, “F2”,
“P1”, “P2” one by one. Press the SET key again to store your current program under the
selected recipe name. This process will overwrite the current recipe data to the saved
recipe data. Figure 10 shows the flow chart of how to save a recipe.
XX
SET SET
SET
SET
SET
SET
SET
SET
SET
SET
SET
SET
XX
2
LCK
End
SAU
b1
SAV
b2
SAV
C1
SAV
C2
SAV
F1
SAV
F2
SAV
P1
SAV
P2SAV
End
SAV
Figure 10. Flow chart of saving a recipe.
9.2 Recall a recipe.
WARNING: You current program will be overwritten by the selected recipe. Please write
it down somewhere if it is important to you. To recall a recipe, press and hold SET key for
2 seconds until the left window shows “LCK” and then release the SET key. The right
window will show “0”. Use “+” key to adjust the number to “1” and then press SET. Then
“rC” (recall) will be shown on the left window and “End” on right window. This can prevent
your current program been accidently overwritten by a recalled program. Use “+” or “-”
key to locate recipe you want to recall. If you press “+” key repeatedly, you will see
“End”, ”b1”, ”b2”, ”C1”, ”C2”, ”F1”, ”F2”, ”P1”, and ”P2” one by one. After you locate the
recipe that you want to recall, press the SET key to select. Current program will be
overwritten by the selected program. Figure 11 shows the flow chart of how to recall a
recipe.