Quick Start Guide
IMEO2
audac.eu
1
2
3
4
The quick start guide gives you an overview of all the functions of the IMEO2. It allows you to
get started with the installation of it in your project. To get a detailed explanation of all functions,
please check the complete manual which is available on the web page https://manuals.
audac.eu/IMEO2 or scan the QR code as shown on top of this page.
1) Status indicator LED’s:
These LED’s indicate the current operation status
of the IMEO2.Various color LED’s indicate following
statuses:
• Red: Standby mode
• Green: (Blinking) USB / (Illuminated) AUX (3.5 mm
jack input)
• Blue: Bluetooth mode
• Orange:(Illuminated) Optical / (Blinking) Coaxial mode
• White: HDMI ARC mode
3) Power button:
The power button allows to switch on and off the unit.
Press to switch the sound bar on. Press and hold
to switch the sound bar off. Repeatedly press (short
term) to switch between the various operation modes
(USB / AUX / BLUETOOTH / OPTICAL / COAXIAL /
HDMI ARC).
2) Remote control (IR) sensor:
The remote control (IR) sensor is located behind the
front grill of the IMEO2. This sensor requires a line-
of-sight connection with the remote control. Make
sure this sensor is not covered or blocked.
4) +/- buttons:
The + / - buttons allow to increase or decrease the
volume level.
Front
To Next Page
Need help?
General
