EasyManua.ls Logo

Audi A3 2012 - Page 248

Audi A3 2012
280 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
246 Fuses and bulbs
I
I
I
No. Equipment
FlO
Engine control module,
main relay
Control module for CAN da-
F12
ta transfer (gateway)
F13
Engine control module (die-
sel engine/gasoline engine)
Fl
4
Engine components (diesel
engine), ignition coils
FlS
F16
F17
F18
Preheating control module/
engine component, tank di-
agnosis, oxygen sensor
Body control module (right)
Horn
Audio amplifier
Flg Front windshield wiper sys-
tem
F
2
0 Water pump/volume regula-
tor valve
F22
F23
F24
F25
F26
Oxygen sensor (diesel en-
gine/gasoline engine)/vac-
uum pump
Clutch pedal switch, brake
light switch
Engine relay, water pump/
engine components/volume
regulator valve
Engine components, water
pump
Pump (ESP/ABS), ABS valve
Body control module (left)
-
Amps
5/10
5
15,20,
25/30
20
5/10
30
15
--
30
30
10/15,
20
10/15
/20
5
5/10
/15
10
40
-·-- --·-
30
40 F27
Secondary air pump, pre-
heating control module
__ , ..
F29
Fuse assignment in the left-
side instrument pane l (spe-
cial equipment)
Power supply relay terminal
15
so
so
Bulbs
Replacing light bulbs
For your safety, we recommend that you have
your authorized Audi dealer replace burned
out bulbs for you.
It is becoming increas ing ly more and more
difficult to replace vehicle light bulbs since in
many cases, other parts of the car must first
be removed before you are able to get to the
bulb. This applies especially to the light bulbs
in the front of your car which you can only
reach through the engine compartment.
Sheet metal and bulb holders can have sharp
edges that can cause se rious cuts, and parts
must be cor rectly taken apart and then prop-
erly put back together to help prevent break-
age of parts and long term damage from wa-
ter that can enter housings that have not been
properly re sea led.
For your safety, we recommend that you have
your authorized Audi dea ler replace any bulbs
for you, since your dealer has the proper too ls,
the correct bulbs and the expertise.
Gas discharge lamp s (Xenon lights)*:
Due to the high electr ical voltage, have the
bulbs replaced by a qualified techn ician.
Head light s with Xenon light can be identified
by the high voltage sticker.
_& WARNING
~
Contact with high-vo ltage components of
the electrical system and improper re-
placement of gas discharge (Xenon) head-
light bulbs can cause serious personal in-
jury and death.
- Xenon bulbs are pressur ized and can ex-
plode when being changed.
- Changing Xenon lamps requires the spe-
cial tra ining, instructions and equip-
ment.
- Only an authorized Audi dealer or other
qualified workshop should change the
bulbs in gas discharge lamps .

Related product manuals