@ Tips
- If a malfunction is present (red symbol),
the distance remaining cannot be called
up.
- Do not reset the display between service
interva ls. Doing so will result in an incor-
rect display.
- If the battery is disconnected, the Serv-
ice Interval Display values are retained.
- On vehicles with the Driver Information
System, you can also call up the service
interval display
¢page 27.
- If service was not performed at the cor-
rect time or the service interval display
was not reset after service was per-
formed, the additiona l mi leage driven or
the elapsed days will be shown as nega-
tive numbers.
Engine oil temperature
display
Applies to vehicles : with engin e temperat ure cont rol dis-
play
Fig. 21 Display: engine oil temperatu re display
• With the ignition switched on, press the
I RESET I button ¢ page 26, fig. 11 repeated-
ly until the engine oil temperature display is
shown.
The engine has reached its operating temper-
ature when the engine oil temperature is be-
tween
176 °F (80 °() and 248 °F (120 °() un-
der normal driving conditions. The engine oil
temperature may be higher if the re is heavy
engine load and high temperatures outs ide.
This is not a cause for concern as long as the
• ¢
page 16 or II¢ page 20 warning light
in the display does not flash.
Dri ver inform ation di spl ay 3 1
Speed warning system
Overview
The speed warning system helps you to keep
your driving speed below a set speed limit.
Fig. 22 Display: speed warning system
The speed warning system warns the drive r if
he exceeds a previously stored maximum
speed. A warning tone will sound as soon as
the vehicle speed exceeds the set speed by
about 3 mph (3 km/h). At the same time, a
warning symbol appears in the display
q fig. 22.
The speed warning system has two warning
thresholds
that function independently of
each other and that have somewhat different
purposes:
'8/8 (Canada models) Speed warn ing 1
You can use speed warning 1 to set the maxi-
mum speed while you are driving. This setting
will remain in effect until you turn
off the igni-
tion, assuming that you have not changed or
reset the setting.
The speed warning symbol
Ci]; [i (Canada
models) in the warning 1 display appears
when you exceed the maximum speed.
It goes
out when the speed falls below the stored
maximum speed.
The speed warning symbol will also go out if
the speed
exceeds the stored maximum speed
by more than about 25 mph (40 km/h) for at
least 10 seconds. The stored maximum speed
is deleted.
Setting speed warning 1
¢ page 32 . .,.
To Next Page
Loading...
