32 Driver information display
8.18, (Canada models) Speed warning 2
Storing warning 2 is recommended if you al-
ways
want to be reminded of a certain speed,
for example when you are traveling in a coun-
try that has a general maximum speed limit,
or if you do not want to exceed a specified
speed for winter tires.
The speed warning 2 symbol ,
[I / [9] (Canada
models) appears in the display when you ex-
ceed the stored speed limit. Unlike warning 1,
it will not go out until the vehicle speed drops
below the stored speed limit .
Setting speed warning 2
¢ page 32.
@ Tips
Even though your vehicle is equipped with
a speed warning system, you should still
watch the speedometer to make sure you
are not driving faster than the speed limit.
Speed warning 1: setting a speed limit
Warning threshold 1 is set by the button.
Fig. 23 Sect ion of instrume nt cluste r: Set/Check but-
ton
Storing the maximum speed
11o- Drive at the desired maximum speed.
11o- Press the knob button ¢ fig. 23 until the
q page 31, fig. 22 symbol appears.
Resetting the maximum speed
.. Drive the vehicle at a speed of at least
3 mph (S km/h)
11o- Press the knob for more than 2 seconds.
The speed warning symbol
[I (USA models)/
ISl (Canada models) will appear briefly in the
display when you release the button to ind i-
cate that the maximum speed has been stored
successfully .
The maximum speed remains stored until it is
changed by pressing the butt on again briefly
or until it is deleted by a lengthy push on the
button.
Speed warning 2: setting a speed limit
Switches in the wiper arm ore used to operate
warning threshold
2.
Fig. 24 Wiper lever: Trip compute r controls
To store maximum speed
.. Turn off the ignition .
11o- Briefly press the button in the instrument
cluster ¢
page 32, fig. 23. The odometer
and the digital clock are now illuminated .
11o- Press the button for at least 2 seconds. The
current ly sto red maximum speed appears in
the display or the crossed out symbol for
warn ing thresho ld 2, if no maximum speed
was set previously .
.. Press the function selector switch in the
wiper
lever@ q fig. 24 up or down to
change the set value. Values run up or down
in steps of 6.2 mph (10 km/h).
To delete maximum speed
.. Turn off the ignition.
.. Briefly press the button in the instrument
cluster ¢
page 32, fig. 23. The odometer
and the digital clock are now illuminated .
.. Press the button for at least 2 seconds. The
currently stored maximum speed appears in
the display.
II>
To Next Page
Loading...
