26 Dr iver information d isplay
Total-trip memory (Trip computer 2)
Unlike the single-trip memory, t he total-t rip
memory is not reset automatically. This per-
mits you to evaluate your driving data for the
enti re period between manual resets.
Fuel range
The est imated cruising range in mile s (km)
appears in th e display. The display changes in
increments of 6 miles (10 km).
Average fuel mileage
The average fuel economy in MPG (l/ 100 km)
since you last cleared th e memory appears in
this displ ay.
Current fuel mileage
The instantaneous fuel consumption in miles
per gallo n (l/ 100 km) is shown in this display.
When the vehicle is stationary, the most re-
cent fuel consumpti on is displayed.
Average speed
The average speed in mph (km/h) since the
last time the display was reset appears in the
display.
Elapsed time
The length of time that you have been driving
since you last reset the memory appears in
this display. The maximum time period that
can be recorded is
999 hours and 59 minutes.
Distance
The elapsed distance since the last time the
memory was cleared appears in the display.
The maximum distance that can be recorded
is
9,999.9 miles (9,999 .9 kilometers).
@ Tips
All stored values will be lost if the vehicle
battery is disconnected .
Operation
The trip computer is controlled by two
switches on the windshield wiper lever.
Fig. 11 Wiper arm/wiper lever: controls for the trip
compute r
Selecting the trip computer
.. Tap the I Rese t I button @ until the trip com-
puter (memory level 1 or 2) appears in the
display
c>page 25, fig. 10.
Selecting the functions
.. Push in t he upper (lower) protr usion on t he
fu nction selector switch ®
c> fig . 11 . The
functi ons fo r t he tr ip compute r are dis-
played in succession on t he respective mem-
ory levels.
Resetting the function to zero
.. Push the I Res et I butto n @ fo r at least two
seconds.
You can reset the following values to zero us-
ing t he
I Re set I but ton :
- driving time
- distance
- average fuel mileage
- average speed
The trip computer only operates when the ig-
nit ion is on. When you turn on the ignition,
the function that was in use when you last
turned the ignition off will be displayed .
(D Tips
- You can also set the values for t he func-
tions to zero in the menu display
(Reset)
c>page27 . .._
To Next Page
Loading...
