Audi A5 - Page 17

17
The settings described above can be saved by
pressing the SET button followed by either of the
memory location buttons. The SET function remains
enabled until the red function indicator LED in the
button goes out.
An acoustic signal is given as feedback after a set-
ting is saved successfully. Again, the prerequisite
for this is that the memory block ON/OFF switch is at
"ON".
Saving settings and adjusting the seats using the programming buttons
If the driver door is open and at "terminal 15 OFF",
the mirrors and the driver's seat can be
adjusted to the pre-configured positions by press-
ing either of the Save buttons once. For this pur-
pose, the driver's door must not already have been
open for longer than 10 minutes.
If the driver door is closed and at "terminal 15 ON",
the Save button must be kept pressed down until
the adjustment is complete. The adjustment can be
interrupted by releasing the Save button.
Saved settings can be retrieved as follows:
To save the current mirror and driver seat settings
to a remote control key,
follow this procedure:
– The settings are saved after closing the driver's
door and locking the vehicle with the remote
control key.
For this purpose, however, the seat back must
not be unlocked.
– After unlocking the vehicle with the remote con-
trol key and opening the driver's door, the mirror,
the driver's seat and the steering column are
adjusted to the positions which have been saved
to the remote control key. The front passenger
seat does not have this function.
However, the function described above will only be
executed properly if two basic requirements are
met:
– "Remote Control Key" must be set to "ON" on the
MMI Car Menu under "Systems", "Seat Settings",
"Driver Seat".
– The memory block ON/OFF switch must be at
"ON".
Saving settings and memory adjustment using a remote control key