Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Unfasten potential equalisation line -2- on body -3-.
– Unscrew securing nut for B+ wire (9 Nm) -1- and pull B+ wire
off threaded connection on power and control electronics for
electric drive - JX1- -2-.
– Clamp off both coolant lines -4 and 5- with hose clamps up to
25 mm - 3094- -3 and 6-.
– Open and pull off both hose connectors -2 and 5-.
Note
Catch escaping coolant using a suitable container.
– Lift power and control electronics for electric drive - JX1- -1-
upwards slightly.
– Disconnect breather hose.
– Lift power and control electronics for electric drive - JX1- up‐
wards out of vehicle.
Removing bracket
– Remove bolts -2- and take bracket (front) -1- off power and
control electronics for electric drive - JX1- .
Audi A6 2011 ➤ , Audi A6 Avant 2011 ➤
Electrical system, hybrid - Edition 03.2014
32 Rep. gr.93 - Electric drive systems
To Next Page
Loading...
