Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Push locking mechanism -4- in direction of -arrow-.
– Starting from left, release and unplug high-voltage wiring har‐
ness for hybrid battery - PX1- / high-voltage wiring harness for
drive motor - PX2- -1- and -2- using release tool - T40258- .
Caution
Only unplug high-voltage connectors by pulling them upwards.
Do NOT rotate or tilt them; this could damage the coding on
the high-voltage wires.
– Place the high-voltage wiring harness for hybrid battery - PX1-
-1- and the high-voltage wiring harness for drive motor - PX2- /
high-voltage wire for electrical air conditioner compressor -
P3- -2- on a cover on the engine.
– Unscrew nuts -arrows- on terminal 30 wiring junction 2 - TV22-
-2- and move terminal 30 wiring junction 2 - TV22- -2- to side.
– Remove bolts -arrows- on bracket (front) -1-.
– Remove bolts and nut -arrows- on bracket (rear) -1-.
Audi A6 2011 ➤ , Audi A6 Avant 2011 ➤
Electrical system, hybrid - Edition 03.2014
6. Components specific to high-voltage system 31
To Next Page
Loading...
