Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Ensure that the red warning label is not damaged.
– Remove bolts -arrows- (9 Nm) and remove cover -1- from
connection box.
– Remove bolts -2- (20 Nm) for high-voltage wires.
– Remove bolts -arrows- (9 Nm) for wiring retainers -1-.
– Pull high-voltage wires -1- upwards out of connection box one
by one.
Caution
Only pull off high-voltage wires upwards. Do NOT rotate or tilt
them; this could damage the coding on the high-voltage wires.
Installing
Installation is carried out in reverse sequence; note the following:
WARNING
Pay very careful attention to the coding of the high-voltage
wires. Mistakes lead to short circuits and irreparable damage
to high-voltage components.
The connector -2- must only be plugged in after the cover has
been fully fitted.
Audi A6 2011 ➤ , Audi A6 Avant 2011 ➤
Electrical system, hybrid - Edition 03.2014
46 Rep. gr.93 - Electric drive systems
To Next Page
Loading...
