Protected by copyright. Copying for private or commercial purposes, in part or in whole, is not
permitted unless authorised by AUDI AG. AUDI AG does not guarantee or accept any liability
with respect to the correctness of information in this document. Copyright by AUDI AG.
– Check that the red warning label is present and take care not
to damage it.
– Remove high-voltage wire for electrical air conditioner com‐
pressor - P3- upwards out of vehicle after loosening wiring
clips.
Installing
Installation is carried out in reverse sequence; note the following:
WARNING
Pay very careful attention to the coding of the high-voltage
wires. Mistakes lead to short circuits and irreparable damage
to high-voltage components.
Note
♦
All cable ties which have been released or cut through during
removal must be re-attached in the same position on installa‐
tion.
♦
Tighten all screw connections to the tightening torques speci‐
fied.
♦
When installing leadthrough in luggage compartment floor,
make sure that it engages and seals securely.
WARNING
Working on vehicles with high-voltage wiring:
• Do not support yourself or tools on high-voltage wiring or
associated components --> this can damage the insula‐
tion.
• High-voltage wiring must not be excessively bent or
kinked --> this can damage the insulation.
• The round high-voltage connectors are colour-coded with
an external coloured ring and are provided with mechan‐
ical coding or guide lugs. It is important to observe this
coding when joining up the round high-voltage connec‐
tors, otherwise the connectors can be damaged.
♦ Coding of high-voltage connectors on power and control elec‐
tronics for electric drive - JX1- ⇒ page 38
Audi A6 2011 ➤ , Audi A6 Avant 2011 ➤
Electrical system, hybrid - Edition 03.2014
52 Rep. gr.93 - Electric drive systems
To Next Page
Loading...
