Attach transmission support 3147 to support bar 10-222A.
Use support bar 10-222A to lift engine/transmission assembly until engine mount bolts are positioned
approx. 1 cm above engine supports.
Remove engine/transmission connecting bolts accessible from below.
Remove upper engine/transmission securing bolts. Leave one bolt hand-tight in place.
Fig. 49: Attaching Lifting Tackle 2024A To Engine And Hook Onto Workshop Crane VAG1202A
Courtesy of VOLKSWAGEN UNITED STATES, INC.
Attach lifting tackle 2024A to engine and hook onto workshop crane VAG1202A.
Remove last securing bolt.
Lift engine over studs of engine mounts.
Loosen support bar 10-222A slightly.
Vehicles with automatic transmission
NOTE:
To balance the center of gravity of the assembly, position hole rails of
hook attachments as shown in the illustration.
CAUTION: Hook attachments and locating pins on lifting tackle must be secured with
locking pins - arrows - in illustration.
NOTE:
Check that all hoses and other connections between engine and body
have been removed.
2005 Audi A4 Quattro
ENGINE 1.8 Liter 4-Cyl. 5V Turbo Engine Mechanical, Engine Code(s): AMB
1:00:56 AM Page 26
To Next Page
Loading...
