Install in reverse order, paying attention to the following:
Bolt lock carrier to longitudinal member (50 Nm) and to fenders (10 Nm).
Fig. 64: Bolt Lock Carrier To Longitudinal Member And To Fenders
Courtesy of VOLKSWAGEN UNITED STATES, INC.
Allow stop for torque reaction support to rest on rubber buffer for torque reaction support under its own
weight, and tighten bolts - arrows - to 28 Nm.
Install front bumper: -->
63 BUMPER
63 - BUMPERS for CABRIOLET
Adjust headlights: --> 94 LIGHTS, SWITCHES - EXTERIOR
Tightening torques
Ribbed belt for generator, vane pump and air conditioner compressor
Component Nm
Lock carrier to longitudinal member 50
fender 10
Torque reaction support stop to lock carrier 28
NOTE:
Mark direction of the ribbed belt with chalk or felt-tip pen prior to removal.
Running a used belt in the opposite direction could destroy it. When
installing the belt, make sure it is properly seated on pulleys.
2005 Audi A4 Quattro
ENGINE 1.8 Liter 4-Cyl. 5V Turbo Engine Mechanical, Engine Code(s): AMB
1:00:56 AM Page 38
To Next Page
Loading...
