Audi AMB - Page 87

Fi
g
. 117: Removin
g
Crankshaft Toothed Belt Sprocket
Courtesy of VOLKSWAGEN UNITED STATES, INC.
 Install crankshaft toothed belt sprocket. To do so, hold sprocket in position with counterhold 3415.
 Install toothed belt (adjust valve timing).
 Install ribbed belt and ribbed belt tensioner.
 Install lock carrier --> Lock carrier, moving to service position.
Tightening torque
*Replace bolt
* 90 ° is a quarter turn
Dual-mass flywheel/drive plate, removing and installing
Dual-mass flywheel
Special tools, testers and auxiliary items required
Fig. 118: Counterhold 10
-201
Courtesy of VOLKSWAGEN UNITED STATES, INC.
 Counterhold 10-201
Removing
NOTE:
 Contact surface between toothed belt sprocket and crankshaft must be
free of oil.
 Do not oil bolt for crankshaft toothed belt sprocket.
Component Nm
Toothed belt sprocket to crankshaft 90 + 90 ° * See note
2005 Audi A4 Quattro
ENGINE 1.8 Liter 4-Cyl. 5V Turbo Engine Mechanical, Engine Code(s): AMB
1:00:59 AM Page 75
cardiagn.com