- Press the appropriate programmed button G), @ or @
to activate the desired remote control function==>
& in
"General information" on
page 96. •
Applies to veh icles : with Home li nk® un iversa l remote cont rol
Reprogramming a single button
A Homelink ® button can be reprogrammed individually
without affecting the other button allocations .
Programming the overhead keypad
- Press the appropriate Homelink ® button until the indi-
cator light begins flashing slowly .
Programming the bumper mounted transmit
ter
1. Hold the original remote control at a distance between 0-
5 in. (0-13 cm) from the bumper below the appropriate
headlight for your vehicle (use the shortest distance
possible).
2. Aim the remote control just below the
driver side head-
light.
3. Press and hold the activation button on the remote
control.
4. The emergency flashers will flash
three times (after about
15- 60 seconds) when the programming is successful.
Now release the button on the remote control.
- If the device utilizes a rolling code, please follow phase 3
of ==>
page 97, "Programming the Homelink ® trans-
mitter" for rolling code programming.
Controls and equip-
ment
Safety first
HomeLink®
This procedure will cause the existing programming on the
Homelink ® button to be erased! •
Applies to veh icles: with Home li nk® universa l remote cont rol
Erasing the programming of the
Homelink ® transmitter
When you erase the programming, the programming on
all three of the transmitter channels with be lost!
- Perform steps 1 to 4 as described on ==> page 97, "Phase 1:
programming the overhead keypad" .
When completed, the Homelink ® system will be in the programming
mode and is then ready to learn the codes for remote controlled
devices .
[I) Tips
• Programmed buttons cannot be erased individually.
• For security reasons you are advised to erase the programming of
the Homelink ® system before you sell your vehicle . •
Vehicle care Do-it-yourself: service Technical data
To Next Page
Loading...
