14
FM Mode
1. To switch the selector on FM mode , the display shows
“FM”. The display will show the frequency and the RDS
info if available. To go through the RDS infos, repeatedly
press the INFO/MENU button (7).
2. To perform manual tuning, repeatedly press the SKIP- /
SKIP+ button (6), when your desired frequency appears
in the display, release the buttons.
3. To activate auto scan for stations, press and hold the
SKIP- / SKIP+ button (6) until it starts to scan down or
up the frequency band, the display will show “Scanning
…”, and it will stop automatically once a station has been
found.
4. To enter into the FM Menu, press and hold the INFO/
MENU button (7), then press the SKIP- / SKIP+ button (6)
followed by pressing the PLAY/PAUSE/SELECT button
(8) to select <Scan setting> and <Audio setting>:
Scan setting - Strong stations only / All stations
Audio setting - Stereo allowed / forced mono
Note: A “*” will be displayed to indicate the current setting.
To Next Page
Loading...