18
Program play
You can use the program play feature to play up to 20 tracks
on a disc in any desired order. You may also program a
particular track to play several times within a programmed
sequence.
1. Load your disc as usual and then press the STOP/SCAN
button (4) to select CD stop mode, the display will show
the total number of tracks in the disc.
2. Press the PRESET/ALBUM button (5) once, the display
will show “MEM” and ashing “P_01”.
3. Press the SKIP- / SKIP+ button (6) to select the rst
track to be programmed. When the desired track number
appears in the display, press the PRESET/ALBUM button
(5) to conrm and the rst track to play is programmed.
The program memory number will advance to “P_02” and
ready for the next entry.
4. Repeat the above steps to program other tracks, a
maximum number of 20 tracks can be programmed.
When you have completed programming, press the
PLAY/PAUSE/SELECT button (8) to begin program play,
playback will be started on the rst track you programmed
and will continue until the last programmed track has
played.
5. When the program play is completed, the player stops
and “MEM” will be still displayed, the player remains in
the program play mode. Press the PLAY/PAUSE/SELECT
button (8) will play the programmed sequence again.
6. To erase the program, in CD stop mode, press the STOP/
SCAN button (4) once; in CD play mode, press the STOP/
SCAN button (4) twice. “MEM” in the display will be
disappeared.
To Next Page
Loading...