Need help?Do you have a question about the Audio Control EQS and is the answer not in the manual?
Offers maximum equalization controls for each area of the audio spectrum.
Increases low output voltage to maximize signal-to-noise ratio and amplifier output.
Automatically switches inputs to maximize equalization controls based on source unit outputs.
High impedance input interfaces with factory source units for amplifier/speaker upgrades.
Helps fine-tune bass response and manage amplifier power by filtering subsonic information.
Install EQS in signal path before amplifiers, mount in accessible, protected location.
Set source unit controls, disconnect amps, adjust input gain until overload LED flickers.
Set amplifier gains to minimum, then adjust output level and source volume for balance.
Addresses no power issues and distorted sound due to incorrect levels or EQ settings.
General| Frequency Range | 20Hz - 20kHz |
|---|---|
| Signal-to-Noise Ratio | >100dB |
| Total Harmonic Distortion | <0.01% |
| Type | Stereo Equalizer |
| Channels | 2 |
| Frequency Bands | 10 |
| EQ Range | ±12dB |
| Center Frequencies | 31.5, 63, 125, 250, 500, 1k, 2k, 4k, 8k, 16kHz |
| Input Sensitivity | 1V |
To Next Page