Copyright © 2006 Audio Note (UK)
Limited
Website
www.audionote.co.uk
E-Mail
info@audionote.co.uk
Telephone +44 (0) 1273 731498
Page 6
Their matched crossovers will also vary from model to model. Some models are available with Black Gate bipolar
capacitors.
It is important to note that you should not attempt to upgrade any driver and/or crossover part yourself. This would
compromise the matching and calibration that these components have undergone.
Our production speakers use an array of methods and materials for the purpose of sealing and of dampening between the
driver basket and cabinet etc. These materials would, however, not be cost effective to use in a DIY scenario (also some
of our formulations are kept secret). The chosen DIY solution to these problems is to use Blu-Tack; of which there are two
packs enclosed (one per loudspeaker).
One recommended component that is not included with this kit, and should not be overlooked, is a high quality audio
grade silver solder (such as our own). This should be used when soldering the leads from the crossovers to the terminals
on the drive units.
To Next Page
Loading...
