Audio Physic AVANTI - Unpacking and Assembly

13
Unpacking and Assembly
1. Place the boxes on the oor, making sure that the product labels are facing up, and carefully open the
packaging on the long side where it has been taped up, preferably using a pocket knife or kitchen knife
(similar to illustrations).
2. Remove the “Welcome to the Audio Physic“ package and the accessories.
3. Keep the box on the oor and carefully remove the loudspeaker together with its protective foam pads. It is
ideal if two people carry out this step. Make sure that you do not touch the drivers when removing and handling
the loudspeaker as this may cause irreparable damage to the drivers.
4. Now remove the top foam cover and carefully slide down the protective foil so that you can easily attach the
spikes that come with the loudspeaker.
5. Screw the caps with the integrated counter nuts onto the spikes.
6. Now turn over the loudspeakers so that the loudspeakers are in stable contact with the oor. Two people
should also carry out this step where possible.
Make sure that you do not hurt yourself on the tips of the spikes.
7. Place the loudspeakers in their intended positions and nely adjust the spikes so that the loudspeakers do
not wobble. If you do not place the loudspeakers in a secure and stable position and they therefore wobble,
this will have a major effect on the sound. When the boxes are standing level and upright, you have set them up
perfectly. The enclosed spirit level will help you to nely adjust the loudspeakers (they are level when the bubble
remains in the inner circle). Now use the lock nuts to again tighten the spikes. Roughly hand-tightening the nuts
is sufcient.
8. Our AVANTI models are tted with a solid front panel without fabric when delivered from our factory. If you
wish, you can exchange this panel for the panel covered in fabric that is also enclosed with your loudspeaker
to suit your tastes. To do so, simply use your ngers to carefully lift off the tted panel. Please ensure that
you do not touch the drivers when doing so. Once you have removed the panel, place the fabric-covered
panel in its position and softly push it in into place until it is ush with the loudspeaker cabinet. You do not
need to worry about any limitations or loss of sound details when using either of the panels.
AUDIO PHYSIC AVANTI english
Right
The loudspeaker upper side
should be on the bottom during
unpacking. If you now carefully
pull the loudspeaker out of the
packaging, you can grip the
loudspeaker on its underside
with the traverses and can easily
attach the spikes.
Wrong
If the loudspeaker upper side
is on top, it is necessary for
you to rst turn the loudspeaker
around after removing it from
the packaging, in order to attach
the spikes to the traverses.