English
2.2 To Speaker or (Subwoofer speaker) terminal
(High level)
Connect speaker wires from the speaker terminals of your amplifier/receiver to the Speaker Level input on the
subwoofer amplifier. Carefully check the polarity of the wires (+ to + and - to -). Connect both Left and Right channels.
The satellite speakers are connected to the main amplifier as usual.
INSTRUCTIONS
Congratulations to your choise of Audio Pro subwoofer and to a new sound experience.
Audio Pro
subwoofer is a unique product built with advanced technique. It is very easy to
handle and install. It is equipped with a built-in amplifier and a long throw woofer. Together with
the extremely solid cabinet , the subwoofer offers a natural and deep bass reproduction at sound
levels you never thought existed.
The Audio Pro subwoofer offers extraordinary performance and lots of possibilities. In order
to get the most out of your new subwoofer, we recommend you to spend time and carefully read
these instructions before you connect and start up your system.
2. INSTALLATION
There are different methods to connect your subwoofer to a HiFi / Home Theater system. In the following we explain
2 different ways. NOTE! Do not connect the mains cord until all other installation is completed.
2.1 To an amplifier / pre-amplifier with Subwoofer-out terminal.
Connect the enclosed wire from your amplifiers subwoofer-out terminal to LINE IN on the subwoofer.
The audio signal is passing through the cord from the subwoofer-out terminal to the built-in amplifier.
By using the LO-PASS control, the upper frequnency of the subwoofer can be variably selected from
50Hz - 150Hz.
Note: Connect the satellite speakers to the main amplifier speaker terminals.
1. UNPACKING
Carefully unpack the Audio Pro subwoofer and check for any damages. If possible, keep the cartonbox if future
transportation is needed.
You should immediately contact your dealer if the subwoofer is damaged .
7
To Next Page
Loading...
