To Next PageTo Next Page
Need help?Do you have a question about the Audio Pro Sub Bravo and is the answer not in the manual?
Amplifier and Woofer| amplifier power | 400 Watt RMS |
|---|---|
| woofer size | 10 inch |
| woofer type | Long throw woofer |
Frequency and Filters| frequency range | 23 - 100 Hz (- 3dB) |
|---|---|
| highpass filter | 100 Hz, 6 dB/octave |
| lowpass filter | 50 - 100 Hz, variable 24 dB/octave |
Weight and Dimensions| dimensions | 350 x 380 x 350 mm (add 3.5 cm for spikes) |
|---|---|
| weight | 19 Kg |
Connect RCA from amplifier's subwoofer-out to subwoofer's LINE IN.
Connect speaker wires from amplifier to subwoofer's HIGH LEVEL INPUT.
To switch the subwoofer amplifier to ON or OFF mode.
Automatically switches to standby mode after input signal ceased.
Shows the operation status of the subwoofer amplifier.
Shows the operation status of the subwoofer amplifier.
Adjusts the sound level of the subwoofer.
Adjusts the crossover frequency between 50 and 100Hz.
Allows switching the phase between subwoofer and satellites by 180 degrees.
Place subwoofer close to a corner for most room amplification.
Experiment with placement to optimize sound quality and match satellites.
Do not cover subwoofer or block the built-in amplifier.
Verify all connections and check for damaged or short-circuited cables.
Subwoofer has protection against high volume and heat.
