3. FUNCTIONS
Power switch (7):
To switch the subwoofer amplifier to ON or OFF
mode. Make sure it is turned OFF during installation.
In ON position the amplifier goes automatically into
standby mode if no signal been detected in 20 minu-
tes. When signal is detected the amplifier starts again.
Turn OFF the subwoofer when it will not be used for a
longer period of time.
Main Power indicator: (RED on front)
The red indicator shows the operation status of the
subwoofer. Red light - subwoofer is on.
Volume control (5):
The sound level of the subwoofer can be adjusted.
Use the Level control carefully, remember that
program material may contain very high energy.
LowPass (4):
The Lowpass crossover frequency can be adjusted
variably between 50 and 100Hz. This gives you a
unique possibility to perfectly match the Subwoofer to
your satellite speakers. The lowest frequencies will be
reproduced only by the subwoofer.
8
English
1
2
3
4
5
6
7
8
To Next Page
Loading...
