To Next PageTo Next PageWhat to do if the ATUC-M does not operate on my Audio Technica ATUC-50?
If the ATUC-M of your Audio Technica Conference System does not operate, insert the ATUC-M connector fully into the microphone jack on the DU/INT until you hear a click. Also, check the microphone settings and ensure that [Phantom Power] is not set to [Off] and [Input Gain] is not too low.
Why do the settings change after reading a preset on my Audio Technica ATUC-50 Conference System?
If you read the preset on your Audio Technica Conference System and the settings have changed, verify that the preset data is correct and that the number and topology of the DUs/INTs have not changed since the last time.
Why is there no sound when playing recorded files from my Audio Technica ATUC-50?
If, after recording with your Audio Technica Conference System, you hear no sound when playing the files on another device, ensure that the recording channel set from [Rec source] is correct.
How to reset the password on Audio Technica ATUC-50?
To reset the password on your Audio Technica Conference System, display the HOME screen of the CU display, then press the BACK button on the CU front panel while rotating the jog dial clockwise until it clicks 3 times. While still pressing the BACK button, rotate the jog dial counterclockwise until it clicks 3 times. Finally, while pressing the BACK button, press the ENTER button.
General| System Type | Digital Conference System |
|---|---|
| Operating Temperature Range | 0° C to 40° C (32° F to 104° F) |
| Maximum Number of Units | 150 |
| Audio Channels | 2 |
| Storage Temperature Range | -20 to +60 °C |
| Connectivity | USB |
| Frequency Response | 20 Hz to 20 kHz |
| Microphone Type | Condenser |
| Polar Pattern | Cardioid |
| Power Supply | AC Adapter |
| Connection Type | XLR |
| Sensitivity | -38 dB |
| Power Requirements | AC 100-240 V, 50/60 Hz |
