10 | Page
13. Setting Camera Address
F1, F2, F3, F4. Press the following
sequence to set an address:
Press * + # + F1 to set Camera Address 1
Press * + # + F2 to set Camera Address 2
Press * + # + F3 to set Camera Address 3
Press * + # + F4 to set Camera Address 4
Key Combinations
Press # + # + # to clear all presets
Press * + # + 6 to restore defaults
Press * + # + 9 to flip switch
Basic Operations
Pairing the RC with the Camera
1. Connect the camera to the PC using a USB3.0
Type-A to Type-B cable.
2. On the Remote control (RC), long-press the
SET and * keys simultaneously for three
seconds; the LED indicator on the RC starts
flashing.
3. Release the SET and * keys.
4. Unplug the USB cable from the camera for
one second and then plug it back in; the LED
indicator on the RC turns off.
Pairing has successfully completed.
To Next Page
Loading...