AudioEngine N22

5
audioengine N22 setup guide
o
p
Using Bare Wire
M Use your thumb and nger to unscrew the
binding post connectors on the back of each
speaker.
N Insert each speaker wire into the holes on the
side of the binding post connectors, observing
proper polarity.
O Retighten the binding posts with your ngers.
P The stripped portion of the wire should be
secured rmly in each connector.
Q Make sure that none of the speaker wire strands
have come in contact with an adjoining terminal.
R Repeat steps 1 and 5 to connect speaker wires to
the amplier.
/
5
/
5
$
%
,13876
/,1(287
86%32:(5
32:(5
287387
/
287387
5
0DGHLQ&KLQD
,QWHUWHN

&21)250672
8/67'
&(57,),('72
&6$67'
&1R
Left SpeakerRight Speaker
Speaker Connections