Step 3 – Connecting the Power Supply
Be sure that the volume/power switch on the front panel is in the OFF
position by rotating it counterclockwise until you hear a click.
Connect the cable with the round end from the power supply to the N22 rear
panel power connector. Note that this connector is “keyed” so line up the
arrow on the cable end with the arrow on the rear panel. Please do not use
excessive force on the connector and use only the power supply provided
with the amplier.
Connect the AC power cable from the power supply to a power outlet and
verify that the indicator light on the power supply is illuminated. We
recommend using a high-quality surge suppressor and/or AC line lter on all
electronics equipment.
Step 4 – Connecting Audio Sources
Using the appropriate audio cable (3.5" mini-jack and/or RCA cable),
connect your audio source (computer, iPod, etc.) to the N22 audio inputs.
One of each cable type is included with your amplier.
Step 5 – Operation
Turn on the N22 volume/power knob and set the volume control to an initial
setting of about 3 o’clock. The front panel power indicator will be
illuminated.
Turn on your audio input source and adjust the volume to your desired
listening level.
Note that both audio inputs on the N22 are active so two audio sources may
be connected to the amplier at the same time without the need for an
input switch. We recommend using the volume control on each audio
source to adjust the overall system volume.
6
audioengine N22 setup guide