S6 Wireless Subwoofer Setup
1
Powered Speakers or Stereo Receiver to S6 Sub
using RCA audio outputs
W3
Sender
O
On
100-240V
~50/60Hz 1.5A
0
180
Phase
Volume
Min Max
50Hz 130Hz
Crossover
Input
Left/LFE
Right
Input
5VDC
Input
Input
5VDC
W3
power
supply
Subwoofer or
audio output
Connect the W3 power supply to the W3 Sender and plug the W3
power supply into a functioning AC power outlet.
If your powered speakers or AV receiver has RCA-style audio
outputs or sub outputs, connect the included RCA adapter “Y”
cable to the W3 Sender.
Connect an RCA cable (included with your powered speakers or AV
receiver) between the RCA “Y” adapter cable and your music source
subwoofer out.
W3 Receiver
Music System to S6 Sub
using mini-jack audio output
Wireless receiver connection to S6 Sub
using mini-jack audio input
Subwoofer input
Connect the included mini-jack cable from the W3
Receiver to audio input on the rear panel of the S6
subwoofer.
Power on the S6 subwoofer.
The status indicators on the W3 Sender and Receiver will
both blink briefly and will then go solid, indicating they
are paired and ready to play your music.
For instructions on setting up the S6 Subwoofer, refer to
the S6 Quickstart Guide.
Need Help?
Visit: audioengine.com/support
Email us: support@audioengineusa.com
Call us: 855-845-5525
Left/LFE
Right
W3
Sender
W3
power
supply
Subwoofer or
audio output
Left/LFE
Right
2
3
1
2
3
4
1
3.5mm
mini-jack
output
2
4
Connect the W3 power supply to the W3 Sender and plug the W3
power supply into a functioning AC power outlet.
Connect a mini-jack audio cable from the W3 Wireless Sender to
your music system audio out or subwoofer output.
1
2
5
5
S6 Subwoofer Setup
V01-1910
The W3 Wireless Audio Adapter, which is part of the S6 Wireless Subwoofer system, will allow you to send music wirelessly from any
music system with an audio output to the S6 Subwoofer.
Here are the two most common setups to make your S6 subwoofer wireless using the Audioengine W3 wireless adapter kit.
S
6
Power on - green
Standby - amber
Auto
on
O
Standby
To Next Page
Need help?
General
