AudioEngine S8 User Guide

Crossover
The crossover control is used to set the subwoofer high frequency cutoff point, which is the point at which the
subwoofer transitions to your speakers. For example, if the crossover control is set to the 50Hz mark then the sub will
play all frequencies up to 50Hz. All frequencies from 50Hz and higher will then be played by the other speakers.
Fine-tune the crossover setting by ear for the smoothest blend with your main speakers. There really are no right or
wrong setting so don’t hesitate to experiment to find the sound that works for your setup.
Phase
Phase is the degree to which the subwoofer and other speakers are moving at the same time. Once you have chosen
a location for your 58, try flipping the phase switch back and forth while you listen for the most bass from your
favorite listening position. Sometimes no difference will be heard, which is OK as there’s no correct phase setting
and it is not uncommon for the subwoofer to sound similar at each setting depending on your room and sub location.
Inputs
The two audio inputs (3.5mm mini-jack and RCA Left/Right) are line-level” inputs for connecting the output of your
music source (AV receiver, preamp, powered speakers, soundcard, TV, etc.) into the 58. Both inputs are open or
active, so you can connect two different sources at the same time and not have to push any buttons to select
between each.
LFE input
If your preamp or AV receiver has an LFE (Low Frequency Effects) output, use the Left/LFE input on the S8 rear
panel.
Power on/Standby indicator
This indicator will be GREEN when an input signal is present (when music is playing) and AMBER when no signal is
present. The 58 will automatically enter Standby mode after 15 minutes if no signal is detected during this time.
Placement
We think you’ll find the S8 to be forgiving with regards to room placement and settings and if you’re not an audio
expert don’t be intimidated with setting up your subwoofer. There really is no right or wrong room placement, so try
different locations while listening to music to get an idea of how the location affects the sound.
Need to go wireless?
If you need to locate your 58 away from your speakers or music system check out the Audioengine W3 wireless
adapters. The S8 has a built-in power port on the rear panel that’s perfect for powering the W3 wireless receiver.
Cleaning
We don’t recommend using any solvents or cleaners on Audioengine cabinets or speakers. Just wipe down with a
soft, dry cloth.
Additional product information
For product specifications, additional setup information and trouble-shooting tips go to:
http://support.audioengineusa.com/solution/categories
Contact support
If you have any questions please contact our customer support team:

AudioEngine S8 Specifications

General

Subwoofer type	Active subwoofer
Subwoofer peak power	250 W
Subwoofer sensitivity	88 dB
Subwoofer frequency range	27 - 180 Hz
Subwoofer crossover frequencies	50 - 130 Hz
Line-out	Yes
Line inputs (RCA)	1
AC input voltage	110 - 240 V
Power source type	AC
AC input frequency	50 - 60 Hz
Power consumption (standby)	8 W
Product color	White
Package weight	13600 g

Weight and Dimensions

Subwoofer width	280 mm
Subwoofer weight	12700 g