21) Press the back panel supports in to
position.
Ensure they are flat with the back panel
rebate.
22) Now we will assemble the master
and slave back panels.
It will help to have a vice with a soft towel
to hold the panel. Alternatively a friend
could be very helpful.
Also, it is a good idea to place tape on
one side of the spanners so they do not
scratch the back panel.
NOTE: After the glue has cured, now is a good time to sand the cabinet and make
it look as you want. Options include iron-on veneer, wood wax, varnish, paint,
scotchprint (vehicle) wrap, etc..
To Next Page