Instruction Manual
Instruction Manual
4
POWER CONNECTION
• Plug the AC POWER CORD (10) to the household outlet. Make sure the voltage
is correct for safety purposes and prevent plausible damages to the set.
Connect one 9V battery (not included) to the battery terminals in the BATTERY
COMPARTMENT (18). It maintains the clock continue function whenever the AC
power is interrupted.
• Please note: the display will not exhibit time during power failure, but the clock
will keep correct time.
RADIO OPERATION
1. Slide the ON / OFF / AUTO switch (12) to the ON position
2. Slide the AM / FM BAND switch (13) to the desired waveband.
3. Tune to the desired station with the TUNING button (16).
4. Adjust the volume level with the VOLUME / BUZZ button (15).
5. To obtain a better FM reception, lay out the FM ANTENNA (11) wire to it’s full
extent.
6. The radio can be switched off by sliding the ON / OFF / AUTO button (12) to the
“OFF” position.
Setting the time
Press the TIME SET button (2) at the same time together with the HOUR SET button
(5) for hour setting or the MINUTE SET button (6) for minute setting.
Setting the alarm
• Press the ALARM SET button (3) at the same time together with the HOUR SET
button (5) for hour setting or the MINUTE SET button (6) for minute setting.
• Select the type of alarm (RADIO or BUZZER) and slide the ON / OFF / AUTO
switch (12) to the “AUTO” position.
RADIO: Wake to the radio, the radio must be tuned to a station which will be
broadcasting at the alarm time with the TUNING button (16) and the volume must
be adjusted to the desired level with the VOLUME / BUZZ button (15).
BUZZER: Wake to the buzzer, slide the VOLUME / BUZZ button (15) to it’s minimum
(in BUZZ position).
Interrupting the alarm (snooze function)
The alarm can be interrupted for 9 minutes by pressing the SNOOZE button (4)
after which time the radio or the alarm (RADIO or BUZZER) will come on again.
To shut the alarm off
To shut off the alarm, press the ALARM OFF button (1) once and the alarm time
will be reset for the next day. Slide the ON / OFF / AUTO switch (12) to the “OFF”
position tom turn off the alarm and not set it for the next day.
Sleep function
1. This clock radio is equipped with a ‘sleep time’ function which will switch off the
radio automatically after a pre-selected period from 59 minutes to 1 minute.
2. Press the SLEEP button (7), the display will show 0:59 minutes of sleep time. At
the same time the radio will come on and stays on for 59 minutes.
3. To shorten the ‘sleep time’, press the SLEEP button (7) together with the MINUTE
button (6) until the desired ‘sleep time’ is shown on the display.
4. After the pre-selected ‘sleep time’ has elapsed, the radio will switch off
automatically. To switch it off before the pre-selected time has elapsed, press the
SNOOZE button (4).
Sleep to radio and wake to radio
1. Set the desired alarm time as described in the paragraph Setting the alarm and
slide the ON / OFF / AUTO switch (12) to the “AUTO” position.
2. Set the ‘sleep time’ as described in the paragraph sleep function.
3. The radio will switch off after the ‘sleep time’ has elapsed and the radio alarm will
switch on the next day.
Dimmer control
The HIGH / LOW DIMMER switch (9) allows you to set the brightness of the display
to HIGH or LOW.
To Next Page
Loading...
