Need help?Do you have a question about the Audiotec Fischer HELIX DSP.2 and is the answer not in the manual?
General| DSP Resolution | 64 Bit |
|---|---|
| DSP Power | 295 MHz |
| Sampling Rate | 96 kHz |
| Signal-to-noise ratio digital input | > 110 dB |
| Signal-to-noise ratio analog input | > 105 dB |
| Signal-to-Noise Ratio | > 110 dB |
| Total harmonic distortion (THD) | < 0.005 % |
| Crosstalk | > 90 dB |
| Weight | 1.2 kg |
| Inputs | 6 x RCA / Cinch 6 x Highlevel 1 x Optical SPDIF (12 - 96 kHz) 1 x Remote In |
| Outputs | 8 x RCA / Cinch 1 x Remote Out |
| Output Voltage | 6 V RMS |
| Frequency Response | 10 Hz - 44 kHz |
| Operating Voltage | 9V - 15V |
| Dimensions (H x W x D) | 40 x 177 x 150 mm / 1.6 x 7.0 x 5.9 " |
| Input Voltage Range | 5 - 15 V RMS |
| Output Channels | 8 |
Read manual carefully and follow all installation instructions to prevent damage or injury.
Ensure correct vehicle voltage and proper wiring for signal processor and electrical system.
Connecting and adapting various input signals like Line and Highlevel for optimal performance.
Procedure for adjusting input sensitivity to match the signal source to prevent damage.
Details on Optical input for digital audio and Power input for DC supply and remote signals.
Procedure for adjusting input sensitivity and connecting digital signal sources.
Instructions for downloading, installing, and connecting the DSP PC-Tool software.
To Next Page
