Need help?Do you have a question about the Audiotec Fischer Match DSP and is the answer not in the manual?
General| Channels | 8 |
|---|---|
| Sample Rate | 96 kHz |
| Crossover | Yes |
| IM Distortion (IMD) | < 0.01 % |
| Outputs | 8 |
Read manual carefully, disconnect battery, install in dry location.
Use only specified connectors, plan wire routing, avoid noise sources.
Connects the MATCH DSP to a PC for configuration via USB.
Connect directly to OEM/aftermarket radio speaker outputs.
Use included terminal, ensure correct polarity, use 1mm²/AWG18 wire.
Connects DSP to OEM radio via Easy Plug Cable without cutting wires.
Download and install the latest PC-Tool software for configuration.
Connect DSP to PC via USB after software installation.
Avoid connecting external amplifiers before basic setup to prevent damage.
Reduces power consumption of connected amplifiers when no signal is present.
Maintains internal voltage even with battery voltage drops during engine crank.
DEP circuit prevents error logs in OE radios with speaker diagnosis.
To Next Page
