- 9 -
AM
Connect the loop aerial (provided) to the 'AM
LOOP ANTENNA' snap terminals at the back of
the unit.
FM
Fully unwind the wire antenna. Then extend the
wire antenna and place it in the position that
sounds best.
NOTE: Do not connect to an outside antenna.
FOR BETTER RECEPTION
TUNING INTO A STATION MANUALLY
The system can store a total of 36 stations. (Each band has a maximum of 24 available preset stations).
Presetting allows you to tune in to a station directly. Stations are assigned preset numbers, beginning from 1
in consecutive order for each band (AM and FM).
1.Press the FUNCTION button to
TUNER, so that TUNER
appears in the display.
2.Press the DISPLAY/BAND
button to select the desired
band.
3.Tune into a station. STEREO
will appear when an FM
broadcast is in stereo.
If the FM stereo broadcast signal weak (for remote use only)
Hold the SHIFT and press the MONO TUNER buttons, so that the STEREO disappear on the display.
To search for a station quickly
Hold the SKIP / buttons and station searching starts automatically. When a station is found,
searching stops automatically.
However, it may not stop if the signal is weak. In this case, search for the station manually.
After use:
Press the POWER/STANDBY button to turn the power off.
Note
The last station tuned in will be recalled, even after changing the tuning band or the function, or after turning
the power off.
To Next Page
Loading...