- 11 -
DELETE THE PRESET STATION
1.Press the FUNCTION button to TUNER.
2.Select a preset station you want to remove.
3.Display the frequency band and frequency:
Press the STOP button, so that the frequency
is flashing.
4.While the frequency is flashing, press the SET/
PAUSE button to delete the preset station. Then
the display will show. FM * ERASED for a few
second, where * is preset number.
Note
After the preset station is deleted, all the remain
station will move up.
When an FM stereo broadcast contains
noise
Press the MONO TUNER button on the remote
control while STEREO disappears on the display.
Noise is reduced, although reception is monaural.
AM step change
AM step can be change (9kHz/10kHz) by press
and hold the DISPLAY/BAND button, and then
press the POWER button at the same time. To reset
this procedure.
Note
When the AM step is changed, all preset stations
are cleared. The preset stations have to be set
again.
Example:
Preset number 1 2 3 4 5
Frequency (MHz) 88 89 90 91 92
Remove the preset number 3
Preset number 1 2 3 4
Frequency (MHz) 88 89 91 92
To Next Page
Loading...