Installing The System Onto Vehicle Seat Back
1. Take one of the supplied straps from the carrier bag and connect the latch to one
of the upper metal rings on the mounting bag. Connect the “S” hook to the other
upper metal ring and place the loop over the headrest. Adjust the strap until the
bag is firmly secured.
2. Take another strap from the carrier bag, and connect the latch to the lower metal
ring on the left side of the bag. Attach the “S” hook to the same ring after looping
the strap around the seat rail. Repeat this process for the right side. In some
vehicles, it may be necessary to attach the “S” connector to the rail directly, as it
may not be long enough to reach back to the ring.
3. Adjust the straps tightly so that the bag is secured.
- 18 -
To Next Page
Loading...
