question type question answer
FREQUENT ASKED QUESTIONS
USB connection
Anomalies when the USB cable is connected
Some portable PCs powered by means of their external power supply create a strong tension difference between the portable PC
USB ground and the Bit One USB ground: this could create temporary anomalies in the digital section of the Bit One. It is
necessary to make the portable PC work with its battery, keeping it disconnected from the network power supply at least when the
portable PC is connected to the Bit One by means of the USB. Once the connection is stable it is possible to connect the portable
PC by means of the power supply without creating problems.
DRC
Difficulty in the passage between the DRC input selection screens. The
system blocks
The problem could be present on some pieces with the first software versions. In this case it is necessary to proceed with the
updating of the Bit One PC firmware and software, available on the web site: http://update.audison.eu
functioning
The unit presents noise from the cd transporter, noise between the
tracks and when you are in the Bit One Table of Contents
The problem could be present on some pieces with the first software versions. In this case it is necessary to proceed with the
updating of the Bit One PC firmware and software, available on the web site: http://update.audison.eu
Problems with the reading of the input levels: the message "input too
low" appears
The problem could be present on some pieces with the first software versions. In this case it is necessary to proceed with the
updating of the Bit One PC firmware and software, available on the web site: http://update.audison.eu
Sometimes the DRC switches off (the Bit One Audison logo remains
turned on). To turn it on again it is necessary to take off and put on the
power plug.
What indicated could happen with the first Bit One and could be caused by the optical digital input or coaxial even if it has been
selected with the unconnected and disactivated source. The problem could be eliminated updating the firmware and the
management software by means of the PCwith the ones you can find in the web site http://update.audison.eu.
Changing the input source, without connected cables and apart from the
source (Aux 1, Aux 2, digital ...),you can hear clamp disturb on the
outputs
The problem is due to Bit One muting and could be solved updating the firmware and the management software by means of the
PC, available on the web site http://update.audison.eu.
During the functioning phase it is possible to hear a light sound
distorsion. You can hear random noises when the Bit One elaborates a
wide spectrum signal with deep low bass: as the tails in high
frequency that come after the low frequency signal. This noise level is
very low but present apart from the type of speaker used and even
using a high pass filter. The noises are more present at lower
frequencies and they are present even after the updating of the unit
software.
The problem can be solved updating the firmware and the management software by means of the PC; available on the web site
http://update.audison.eu.
Why are there 3 remote inputs and only 1 remote output?
The three Remote IN inputs are requested for the Bit One remote turn on using one or more signal sources. Instead, the Remote
Out function turns on in remote the units or amplifiers connected down to the processor. The three Remore IN inputs are
connected in parallel, so if even one source is present it is possible to use without exception each of the three inputs.
Using the Bit One in “Filter Linkwitz” mode, when selecting the cutting
slope [dB], you hear a ''puk' sound
The problem could be solved updating the firmware and the management software by means of the PC, available on the web site
http://update.audison.eu.
Elettromedia srl 2/3 rev 00
To Next Page
Loading...
