Why do I need to uninstall and reinstall Audison bit one Signal Processors drivers?
If other applications have overwritten the USB-ACLink drivers, even partially, you will need to uninstall and reinstall the drivers.
What to do if DRC display shows “PC control - DRC is disabled” on Audison Signal Processors?
If the DRC display shows “PC control - DRC is disabled”, the PC is correctly initializing the ACLink bus, but the fault is in the Bit One. To resolve this, exit the program on the PC, turn the Bit One off then on again, and then try reconnecting.
What to do if I get repeated error messages after turning on the Audison Signal Processors Bit One again?
Perform the ACLink drivers installation again.
Why does the DRC display show the message “audison: vol bal fad sub” on Audison bit one Signal Processors?
The message “audison: vol bal fad sub” on the DRC display indicates a fault in the PC. This could be due to a wrong installation of the software or the drivers, or due to undetectable problems on an operating system or hardware level.
Step-by-step guide for installing the Bit One PC software.
Instructions for installing the necessary drivers for the Bit One.
Procedure for uninstalling the Bit One PC software.
Steps to remove Bit One drivers on Windows Vista.
Steps to remove Bit One drivers on Windows 7.
Steps to remove Bit One drivers on Windows XP.
Important warnings before starting the Target mode setup.
Configuring the low-level master input channels.
Configuring the high-level master input channels.
Step-by-step guided procedure for setting up the Bit One.
Loading, saving, and finalizing system setups.
Accessing and managing various configuration settings.
Downloading and preparing files for firmware updates.
Performing and verifying firmware updates for Bit One and DRC.
Steps to enter and use the rescue mode for device recovery.
Detailed steps to upgrade the DRC firmware.
General| Number of Channels | 8 |
|---|---|
| Output Channels | 8 |
| Crossover | Yes |
| Time Alignment | Yes |
| THD | 0.005 % |
| Type | Digital Signal Processor |
| DSP Resolution | 32-bit |
| Crossover Slope | 6/12/18/24 dB/octave |
To Next Page
