ADVANCED MANUAL / Bit One /
53
*2 This entry is only active if
amplifiers featuring the
Amplifier Status Controller
are connected to the
Bit One through the
ADLink / ACLink
connection system.
12.2
SEL BUTTON - FUNCTION
By pressing the SEL button you can access
:
*1 Dual Power Memory: this entry is active only if
amplifiers featuring Dual Power and Bias Control
(Thesis TH) are connected to the Bit One. You can
recall the pre-sets set in each amplifier.
- DSP Memory: the A/B/C/D set memories can be recalled
(through the software) and stored in the processor
(Bit One).
- DSP Settings: through this menu you can enable/
disable the Dynamic EQ as well as the Auto IN Level Adj.
Function.
- Auto IN Level Adj: if while listening to the music the
MASTER source volume moves and you do not have any
indications about its original level, to correctly set it back
to the level it was when it was initially tuned, insert the
“SETUP CD” into the head unit, play track 1 and press
the “yes” button on the DRC. Now adjust the MASTER
source volume until the cursor (+) is on “0” and not over
(to avoid the clipping).
- Brightness: to adapt the DRC to the light conditions
inside the car compartment you can adjust the display
and the red switch bezel brightness.
The PHONE input can not be selected as normal source
because it activates exclusively when an external hands-
free phone kit sends the MUTE impulse when receiving
a phone call. The DRC display will show the message
shown on the right, the Bit One will set the source
selected in that moment to muting, reproducing the signal
coming from the PHONE input.
During the phone call the volume can be adjusted through
the DRC knob.
Please, note that in any case you can pre-set the volume
of this “source” and customize an adequate equalization
curve through the software.
12.1 PHONE CALL
12
To Next Page
Loading...
