Audison bit one - Main Menu: File Operations

ADVANCED MANUAL / Bit One /
31
Clicking on the “File” tab a drop-down menu shows up listing
the entries shown in the image on the right of the page:
3
FINALIZE to Bit One: it provides the ability to load into the Bit
One microprocessor internal memory all the settings that you
selected while setting up your system. This function lets the Bit
One work without being connected to the PC.
When running the Finalize to Bit One function, the software
notifies you that the data entered in the Bit One will be
overwritten.
- Click YES to load the data set inside the Bit One, overwriting
the data that have been previously saved, if any.
- Click NO to interrupt the process.
In OFF LINE mode this feature lets you view the features that
you have previously saved to review them.
WARNING: Files saved with firmware versions
older than v. 1.5.0.0 can not be loaded into
the Bit One.
1 Load Setup..: by selecting this entry, the Bit One entire
Setup is loaded from a previously saved file
(EX. “BitOneConfig1.bit”). This feature is available both in
TARGET and in OFF LINE mode.
In TARGET mode this feature lets you load again all the
settings that have been previously saved. This feature
is useful if you want to resume all the settings you have
previously selected to install another Bit One with the same
settings, in order to test different acoustic setting.
2
Save Setup..: it saves the Bit One entire Setup in a file
(EX. “BitOneConfig1.bit”) that you can then load again
inside the Bit One in a second time through the “Load
Setup” function. This feature is available both in TARGET
and in OFF LINE mode.
You will be able to use the Setup you saved only with
Bit Ones where the same Firmware version is installed,
or where firmware versions that are more recent than v.
1.5.0.0 are installed.
9.2 MAIN MENU: “FILE”
WARNING:
before disconnecting the Bit One from the PC or each time that you exit the PC Software after
modifying the system configuration always run the Finalize to Bit One procedure.
If you do not follow these instructions all the data entered will be lost.
1
2
3
4
5
6
7
8
9
10
1
9