ADVANCED MANUAL / Bit One /
17
- If you receive error messages when installing the software or the drivers, check if the user account you are using on
your PC has admin privileges.
- If the PC that is connected to the Bit One shows an error message regarding the connection with the Bit One
(for example “Bit One device not found”), check the following points:
•
If the DRC display shows the message “audison: vol bal fad sub”:
There should be a fault in the PC, for instance due to a wrong installation of the software or the drivers, or due
to undetectable problems, on an operating system or hardware level.
•
If the DRC display shows the message “PC control - DRC is disabled”:
In this case the PC is correctly initializing the ACLink bus but the fault is in the Bit One. Exit the program on
the PC, turn the Bit One off then on again, then try reconnecting.
If after turning on the Bit One again one of the above messages appears, you may need to perform again
the ACLink drivers installation.
You may be required to uninstall and reinstall the drivers also if other applications overwriting, even partly,
the USB-ACLink drivers have been installed
(see section 7).
6.3
TROUBLESHOOTING SECTION FOR SOFTWARE INSTALLATION
6
To Next Page
Loading...
