Audison bit one - 8 How to Connect the Bit One to the Pc; OFFLINE Mode

ADVANCED MANUAL / Bit One /
21
8. HOW TO CONNECT THE BIT ONE TO THE PC
To adjust the Bit One functions the software is required. The processor needs to be connected to the PC and turned
on. After installing the software, start it by clicking on the icon shown on your desktop.
To select the start mode select the corresponding entry on the drop down menu, then press ENTER or double click
on the Bit One image.
In this case even if the Bit One processor is connected to the PC, it does not interact with the software.
The OFFLINE mode can be used to work on the software without connecting the Bit One to the PC to get familiar with the
processor multiple functions.
For more information on the specific functions see section 8.3 for the TARGET mode.
The software is pre-set to start with a 3-way + stereo Sub active multi-amplified system.
To set a new “virtual” system, and so to change the inputs and select the outputs, you need to select the function I/O
Configuration Wizard in the “Config” window of the software main menu.
(
Follow same instructions as those for the TARGET mode - see section 8.3.1)
Here is how the Bit One software appears when it is started up in OFFLINE mode.
The first screenshot showing up is the start up page where you need to choose among:
- OFFLINE mode, Bit One not connected;
- TARGET mode, Bit One connected;
- RESCUE mode, Bit One connected for Update/Rescue
(see section 10.1).
8.1 OFFLINE MODE
2 click
8