Audison bit one - Target Mode Startup Warnings; Target Mode Setup Procedure

ADVANCED MANUAL / Bit One /
22
In this case the Bit One processor has to be connected to the PC and turned on, otherwise the software won’t even
show the TARGET entry as selectable on the start up window.
At this point you need to have in mind the system you want to realize beforehand, since from this moment if you want
to change any of the settings you will have to go through the guided procedure all over again.
More specifically the guided procedure will ask for:
- Which main inputs you want to use (high or low level). Once you select your choice, auxiliary low level or digital
sources can anyway be added. The guided procedure changes according to the selected choice.
- Which auxiliary inputs will be used (ex.: AUX1 or DIGITAL IN or PHONE etc. ).
- Which kind of signals will be allocated to the different inputs (ex.: Front Left or Center or Subwoofer etc. ).
- Which speakers you are using for your system (ex.: 3-way Front or stereo Sub or 2-way Rear etc. ).
- If the system features passive crossovers managing speaker groups (ex.: 3-way system with active mid-low).
- If the system features any speaker connected through the ACLink.
2. If you are using a computer equipped with a serial port,
the software will perform a scan of the PC port looking
for the Bit One
(Fig.1).
Then the PC will find the Bit One connected to the
“ACLink interface”
(Fig.2)
- Click OK to start up the TARGET mode;
- Click NEXT to search again for the USB port;
- Click CANCEL to start up the OFF LINE mode.
3. If, once the scanning is completed, the Bit One can not be found
(Fig.3):
- Check if the Bit One is on (check if the Audison logo is lit up);
- Check if the USB cable is properly connected;
- Click RETRY to search again for the Bit One;
- Click CANCEL to start up the OFF LINE mode.
1. When starting up the software, if it has been correctly interfaced to the PC (with software and drivers properly
installed), the dialog window shown in
section 8.3.1, will appear on the screen.
1. Guided procedure to set the desired car audio system.
Press NEXT to go on with the setting.
Press CANCEL to exit the program.
8.3 TARGET MODE
The procedure starts automatically.
8.2 STARTING UP THE BIT ONE SOFTWARE IN TARGET MODE - WARNINGS
Screen
image
sequence
Fig.3
Fig.1 Fig.2
1
8